PANIC ! H3 wont start !

[lsv_palana]

I have found reason for multiply errors and locking automatic transmission handle.. i have removed fuse ign batt switch 05 to empty position... now it on it place.. errors gone.. padlock gone from panel... trying to put fuel tank back.

Отправлено с моего SM-N910C через Tapatalk

 

[lsv_palana]

I have fixed my car.. it works fine now.. here is a problem:

Melted contact on big harmess that goes under car and for back.. found it with tech2 turning on fuel pamp and checking amps of voltage... maked cross with another wire...

Отправлено с моего SM-N910C через Tapatalk

 

[lsv_palana]

By the way, dear friends what is it ? :

Located near battery...

Отправлено с моего SM-N910C через Tapatalk

 

[Bruces]

If it loops battery cable it monitors amps of alternator

 

[JPaul]

Sure seems to be a lot of connectors that melt on these cars, the blower motor, the rear defroster, and now this ones are the ones I know of...

Sent from my Nexus 7 using Tapatalk

 

[lsv_palana]

So can i read by tech2 or obd2 amps of alternator ?

Отправлено с моего SM-N910C через Tapatalk

 

[JPaul]

Seems if the PCM is reading it you should be able to with the tech2 at least. If you can find the codes for ODB2 then please share them, I'd love to get those added to my Ultragauge. I've tried searching for them but I haven't been able to find anyone that's figured them out yet.

Sent from my Nexus 7 using Tapatalk