H3 Do it yourself... Front crossmember bushings from outfitter design

[hodges81]

http://www.outfitterdesign.com/do-it-yourself-front-differential-bushing-kit.html

WHAT DO Y'ALL THINK OF THIS FIX? I'VE BEEN TRYING TO GET THE SCORPWORKS REPLACEMENT BUT AREN'T GETTING ANY EMAILS OR CALLS BACK... HELP IS APPRECIATED!!!

 

[Zach]

Send a pm to either Alrock or Bigunit. They will get you in touch with Scorpion

 

[Best4x4]

I had no issues getting in touch with Scorp! Already have my new CM installed and my old one is on it's way back to Scorp! I like the tie rods from that company mentioned above though!! No more 16mm lol

 

[cbetts]

The replacement diff end mount bushing look interesting. I blew the right side but I do not know if it was from the center mount breaking.

 

[alrock]

The side bushing mounts are a PITA to remove from the plate. I tried it on a test project for another vendor a few years ago (not PCF). While the side ones can break, it's not as common. Actually, I have not broken my original driver's side one and I went through two passenger ones in 6 years/130K miles.

I think the right side one breaks for two reasons: 1) more diff weight on that side and 2) torque from the drivetrain stresses that side more than the left side.

(BTW, I think the OP got in touch with PCF)