Cleaned out dusty engine compartment, now throwing P2176, P2101, P0030, & P0036 codes

[evldave]

ok, so decided to lightly use my compressor to clean a bunch of the dust out of my engine compartment. Now I'm throwing the P2176, P2101, P0030 and P0035 codes and the truck goes into 'limp' mode. I can clear them while the truck is running and about 50% of the time it works and the truck drives fine. Sometimes it takes 3-4 clears before the codes actually clear and it'll drive fine.

I checked and cleaned all the fuses and relays in the main fusebox, just in case one of them was loose.

P0030 code is Heater Control Circuit Bank 1 Sensor 1
P0036 code is Heater Control Circuit Bank 1 Sensor 2
P2101 is Control Module Throttle Actuator Position Performance
P2176 is Minimum Throttle Position Not Learned

I'm thinking I might have either blown loose a connection or got dust somewhere (TPS maybe?).

As a note, the truck will start and run fine when cold. This only happens when it's partially or fully warmed up.

Any ideas?

 

[erdlen65]

When minr was throwing the p2101 and p2176 it was the pedal assembly... Did you try taking the battery terminals off so the computers reset? I would start by checking your wiring harness to make sure you didnt pop any clips apart around your intake manifold

 

[evldave]

Ok so went through and checked every sensor I could reach without completely tearing engine apart. No error codes so far hopefully was just a clip and not something more serious.

Sent from my MB860 using Tapatalk

 

[Chris5556668]

Which clip?

 

[Chris5556668]

Have same issue and could not resolved it