BA bumper questions.

[cgalpha08]

Im looking to buy a hawse fairlead for the BA, im assuming and standard one will fit? do they come with the proper hardware to bolt right on? Im looking at getting the stainless steel polished one form warn. I know these are total noob questions but i would like to avoid finding out the hardway. Thanks.

 

[4speedfunk]

All 8K-12K lb/ winches use the same bolt-pattern. This is true for both the winch and the fairlead.

Below 8K lbs....both use a smaller size (typically used on quads and side-by-sides).

Also...if you can wait until September 21st, you can walk-in to the 4WD Jamboree at the Indiana State Fairgrounds and buy all kinds of goodies for way less than anywhere else. No shipping either!

http://www.4wheeljamboree.com/event/267

If the weather is nice....I might run up there in Warren and sell some bumpers off the trailer.

 

[Bigunit]

I have a black one from Warn brand new, in the box, if you decide against the stainless. I bought for my BA bumper but went with a black powder-coated aluminum hawse fairlead.

Sent from my DROID RAZR using Tapataint

 

[cgalpha08]

I have a black one from Warn brand new, in the box, if you decide against the stainless. I bought for my BA bumper but went with a black powder-coated aluminum hawse fairlead.

Sent from my DROID RAZR using Tapataint

Darn. I already ordered the polished one. I also read bad reviews about the channel where the rope goes through being too rough for the synthetic stuff. Thanks tho!

Sent from my DROID BIONIC using Tapatalk 2

 

[supersapper-rpm]

I might take that black one for my BA bigunit. Pm me the details on it if you could. Thanks

 

[Bigunit]

You can have it Rich. I will throw it in the care package I am sending you.

Sent from my DROID RAZR using Tapataint

 

[H3DONIST]

Darn. I already ordered the polished one. I also read bad reviews about the channel where the rope goes through being too rough for the synthetic stuff. Thanks tho!

Sent from my DROID BIONIC using Tapatalk 2

I bought mine used, so it may have been modified, but I put an aluminum hawse fairlead on my BA bumper and there is plenty of clearance in my opening.