H3 2" Body Lift

[amrg]

Those are the oem flares, 4cm wide.

Sent from my SM-G960F using Tapatalk

 

[StandoutAlpha]

@amrg
Did you find any info on extending the H3's steering shaft/linkage?

 

[Sennin]

no extension required on a 2" body lift :thumbs:

 

[amrg]

According to Humvee when he did his 2" bodylift afterwards, the garage lifted the body 4" before installing the 2" blocks. So the steering still has enough extension left over a 2" bodylift but it would be safer to extend it if you decide to go over 2". At that point it would also be advisable to either drop the radiator or get a custom taller radiator (since the clutch fan becomes way off center to the rad at aboce 2")

Sent from my SM-G960F using Tapatalk

 

[StandoutAlpha]

I mind as well go 2" body lift and figure something else to make them not rub.

Have you tried the front diff drop spacer?

 

[amrg]

Diff drop doesnt do anything with respect to tire clearance. But I fabbed my own spacers from 1" PU body mounts as well as steel plates to drop the rear diff cross member

 

[StandoutAlpha]

Nice job!
How high is your torsion bars cranked? Is it more than 23"in.

 

[amrg]

Yes. But i recranked to 23.75" after the drop. Planning on 24" after getting new UCA

Sent from my SM-G960F using Tapatalk

 

[Gpcalero]

Awesome write up Amrg. I may do a body lift on my T soon.

 

[ConcealedGLOCK]

Do you have a photo of your h3 without the 2” bl next to your bros jk? Would like to see a before and after comparison photo.

 

[amrg]

Thats abit difficult since I had a 1" bl and 35s when he bought it.

Sent from my SM-G960F using Tapatalk

 

[amrg]

Not my brothers and only from the rear.

Sent from my SM-G960F using Tapatalk